Everyone knows Luke Skywalker travels to Dagobah to learn the ways of The Force (like his father before him). He trains with Jedi master Yoda. Perhaps you recall the scene where Luke does a one-armed handstand while balancing Yoda on one foot. Yes, for a real person this is pretty much impossible—but not for a Jedi.
Ok, so here is the plan: I am going to use Luke’s pose to estimate the mass of Yoda. This will be all about the center of mass. If the Luke-Yoda system is in equilibrium, then the center of mass for the entire system must be directly above Luke’s one hand on the ground. (If you want a more detailed explanation of center of mass and balance, check this post where I use center of mass to estimate the mass of Darth Vader.) To do this, I will make the following assumptions:
The paper I listed has multiple representations of the human body. Just to be clear, I am going to use the values based on Dempster. I am going to represent my human (or alien that looks like a human) as a five-point mass. Here are the locations and values of these masses:
Now we can look at the Luke-Yoda system. Here are those point masses (including Yoda). A helpful tip: Even though I am looking at an image, Tracker Video Analysis can be useful for measuring points.
I don’t really care about the vertical position of the total center of mass, but with this data I know the total x center of mass must be zero (since I put the origin at Luke’s hand). The x coordinate of the center of mass of the whole Luke-Yoda system would be:
Here I am using the notation of xrl for the x-position of the right (r) leg (l). Hopefully that makes sense. Now I know all of these values except for the mass of Yoda. It’s time for a wee bit of algebra (assuming xcm = 0 meters) I can get:
Using the x-position values from the video along with the mass values from my estimations, I get a Yoda-mass of -43.7 kg. Yes, that is a negative mass. But what does that mean? It means that in order for Luke to balance in that position, Yoda would have to pull UP on his leg rather than push down. One way to pull up would be to have a negative mass (which we don’t see). The other way for Yoda to pull up on Luke would be with The Force.
No, Luke is not using the Force to hold Yoda up. In fact, even if Luke was doing a handstand without Yoda pulling up, his center of mass would be 12 cm to the right of his hand. He would tip over. Why is it that Yoda using The Force and not Luke? Luke doesn’t know what he is doing. He couldn’t even lift the X-wing (which happens right after this). He’s just a student. Yoda was just helping Luke because he wanted him to feel a small sense of accomplishment after his failure in the cave.
Clearly this post will require some feedback. As the unofficial inventor of preemptive comments, I must occasionally reply to your comments before you even comment.
One last thing. Real handstands are difficult, but one-handed handstands are doubly difficult. When you put two hands on the ground, it is fairly simple to adjust the force your two hands exert on the ground to create torque that brings you back into equilibrium. For front and back motion, you would have adjust your body’s center of mass to stabilize your position. Now when you switch to one-handed handstand, you must adjust your center of mass in both the front-back and side-to-side directions for balance. This is tough. Oh, and you have to support your weight with just one arm.
Go Back to Top. Skip To: Start of Article.
Find out more by searching for it!